1. Welcome to Jeeps.net!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Jeep discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Jeep owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Wagoneer won't restart after driving for a while

Discussion in 'Other Jeep Vehicles' started by jeepnut45, Sep 29, 2017.

  1. Sep 29, 2017 at 11:36 AM
    #1
    jeepnut45

    jeepnut45 [OP] Member

    Joined:
    Sep 28, 2017
    Member:
    #1919
    Messages:
    5
    Gender:
    Male
    First Name:
    Paul M
    Vehicle:
    '83 Wagoneer
    1959 Willys Wagon, 300 ci Buick engine 4wd
    My '83 Jeep Wagoneer will not restart after driving for a while in traffic. Will crank over but will not fire. Sometimes starter fluid helps. Can't tell if this is vapor lock, poor gas flow, overheated engine, etc. Suggestions.
     
  2. Sep 29, 2017 at 12:18 PM
    #2
    OFFGRID

    OFFGRID Well-Known Member

    Joined:
    Oct 3, 2016
    Member:
    #317
    Messages:
    2,018
    Gender:
    Male
    First Name:
    Peter
    Houston
    Vehicle:
    1979 Jeep CJ7, 258, TH350, NP208
    Howell fuel injection, header, HEI distributor, TH350, NP208, SOA lift with YJ springs in the front & GW springs in the Rear. AMC20 with G2 1 piece chromos trussed, Dana 30 with G2 chromos and 760x ujoints and MM Stainless Hubs, Geared 4.56. Tom Woods shafts, Metal cloaks, Caged, 37" Toyo MTs.
    Will crank, but not start is either fuel, air, or spark. I'm going to rule out air because I'll assume you do regular maintenance and the filter is clean. That leaves fuel or spark.

    You said sometimes starter fluid helps. Right now using starter fluid will it start and then die, or will it just keep turning over. If it starts and dies I will guess it is an inline fuel filter that is clogged or a bad fuel pump.

    If using starter fluid and it won't start at all and just keeps turning over I will guess it is somewhere in the ignition system. Maybe the coil. Check the coil by removing a plug wire from from a plug and holding it close to a ground like the engine block and see if it arcs when someone is cranking the motor. I would hold it with a set of plug wire pliers or rubber handled pliers to prevent yourself from being shocked in the even of a frayed wire. Check your connections on the coil and make sure they are making good contact.
     
    Bob, JKBob 25 and aggrex like this.
  3. Oct 7, 2017 at 9:28 AM
    #3
    jeepnut45

    jeepnut45 [OP] Member

    Joined:
    Sep 28, 2017
    Member:
    #1919
    Messages:
    5
    Gender:
    Male
    First Name:
    Paul M
    Vehicle:
    '83 Wagoneer
    1959 Willys Wagon, 300 ci Buick engine 4wd
    I got a new ignition module from PartsGeek and that fixed the problem.
     
    OFFGRID, JKBob 25 and chris4x4 like this.
  4. Oct 7, 2017 at 9:48 AM
    #4
    chris4x4

    chris4x4 With sufficient thrust, pigs fly just fine Moderator

    Joined:
    Jul 19, 2016
    Member:
    #2
    Messages:
    4,068
    Gender:
    Male
    Thanks for the update!
     
    JKBob 25 likes this.
To Top