1. Welcome to Jeeps.net!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Jeep discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Jeep owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Axle: my 2014 Patriot has a trans and transfer from a 2011 same vehicle

Discussion in 'Performance & Tuning' started by Teedoffjeep, Dec 2, 2019.

  1. Dec 2, 2019 at 11:06 AM
    #1
    Teedoffjeep

    #1
    Teedoffjeep [OP] New Member

    Joined:
    Dec 2, 2019
    Member:
    #4157
    Messages:
    1
    Gender:
    Female
    Vehicle:
    2014 Jeep Patriot 4whl drive
    2011 transmission/transfer case
    On the passenger side the axle is 31", I replaced it and seal went out at about 150 miles...shouldn't this be a 1/2 shaft assembly with a stub in the transfer case to help lesson the load on output? I found the parts that fit and am just wondering if this was changed. Thanks
     
    Teedoffjeep, Dec 2, 2019
    #1
  2. Dec 2, 2019 at 11:51 AM
    #2
    aggrex

    #2
    aggrex Well-Known Member

    Joined:
    Sep 12, 2016
    Member:
    #203
    Messages:
    4,839
    DE
    Vehicle:
    Backcountry '16
    Tuffy>AEV>TTO>JW>STech>EVOcage>MagnaFlow>SpiderTrax>RockHard>TF>SpringTail>67design>Bolt>GPCA>Curt>
    Welcome @Teedoffjeep ...not a Patriot specialist but always interested in the solution. The jeep parts counter person should be able to confirm what axle or shaft parts fit your specific VIN vehicle. Things do change between specific years and the jeep parts department will be the best choice for accurate information. Post up your resolution for the Patriot.
     
    aggrex, Dec 2, 2019
    #2
Register FREE to Reply!
To Top