1. Welcome to Jeeps.net!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Jeep discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Jeep owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Daytime running lights and Halo don't run unless manually put on

Discussion in 'Lighting' started by Flanker73, Nov 21, 2020.

  1. Nov 21, 2020 at 11:07 AM
    #1
    Flanker73

    Flanker73 [OP] New Member

    Joined:
    Nov 21, 2020
    Member:
    #5260
    Messages:
    1
    Gender:
    Male
    After market LED lights and switch back running lights
    So I got a great set of new LED lights : KIWI MASTER 9 Inch Round LED Headlights Halo DRL for 2018 2019 Jeep Wrangler JL Accessories High Low Beam Headlight with Daytime Running Lights (New V and the setup was nice and easy. Wired the lights to the DRLs wire but the halo won't work unless I turn my DRL on manually. They won't work on the "Auto" setting.

    I then installed after market plug and play switchback front signal and DRL kit : 1 of Diode Dynamics Switchback Front Turn Signal and DRL Kit for 18-20 Jeep Wrangler JL & Gladiator JT Rubicon, Sahara and Overland (Stage 2 Kit) Again, they now only work on the "Auto" setting.

    Can anyone tell me what I did wrong? Seems simple enough so I feel stupid.
     

Products Discussed in

To Top