1. Welcome to Jeeps.net!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Jeep discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Jeep owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Looking to convert Dana 44 m210 front axle to free-spin hubs

Discussion in 'Gladiator (2020+)' started by FrankenTruck, Nov 2, 2024.

  1. Nov 2, 2024 at 12:03 PM
    #1
    FrankenTruck

    FrankenTruck [OP] New Member

    Joined:
    Oct 26, 2024
    Member:
    #8963
    Messages:
    4
    Gender:
    Male
    Hello everyone, new here...
    I need to have free spin hubs on my gladiator dana 44 m210 front axle.
    I have installed this axle in another project (not a gladiator obviously)and cannot use the FAD system, long story short it is a huge pain. I know how to eliminate the FAD and install new axle shafts, no worries. Now I need to know if it's even possible to convert the hubs. I have researched it and haven't found anything specific for that axle.I can't have the front end turning when I'm not in 4 wheel drive,not an option.I know it's outdated technology, but on this build it is absolutely necessary for what I need for this truck to do. Any info or directions to a forum on this topic would be greatly appreciated.
     
  2. Nov 5, 2024 at 4:16 AM
    #2
    Bob

    Bob Well-Known Member Moderator

    Joined:
    Jul 18, 2016
    Member:
    #1
    Messages:
    793
    Gender:
    Male
    Find any info on this yet?
     
  3. Nov 9, 2024 at 10:57 PM
    #3
    FrankenTruck

    FrankenTruck [OP] New Member

    Joined:
    Oct 26, 2024
    Member:
    #8963
    Messages:
    4
    Gender:
    Male
    No I haven’t. Could you point me in the right direction please?
     
To Top