1. Welcome to Jeeps.net!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Jeep discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Jeep owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Running lights not working after stereo installation

Discussion in 'Cherokee' started by Fixinjoesjeep, Jan 7, 2017.

  1. Jan 7, 2017 at 2:26 PM
    #1
    Fixinjoesjeep

    Fixinjoesjeep [OP] New Member

    Joined:
    Jan 7, 2017
    Member:
    #758
    Messages:
    1
    Gender:
    Male
    First Name:
    Brian
    Vehicle:
    2000 grand Cherokee
    After helping my son install a new stereo in the Jeep the running lights no longer come on. We hooked up the harness for the stereo wire by wire correctly leaving two extra wires. I'm sure that these are the two wires that caused the issue but where do I put those two wires now any ideas would be helpful.
     
  2. Jan 7, 2017 at 3:35 PM
    #2
    OFFGRID

    OFFGRID Well-Known Member

    Joined:
    Oct 3, 2016
    Member:
    #317
    Messages:
    1,815
    Gender:
    Male
    First Name:
    Peter
    Houston
    Vehicle:
    1979 Jeep CJ7, 258, TH350, NP208
    Howell fuel injection, header, HEI distributor, TH350, NP208, SOA lift with YJ springs in the front & GW springs in the Rear. AMC20 with G2 1 piece chromos trussed, Dana 30 with G2 chromos and 760x ujoints and MM Stainless Hubs, Geared 4.56. Tom Woods shafts, Metal cloaks, Caged, 37" Toyo MTs.
    Check your fuse box for any blown fuses.
     
  3. Jan 7, 2017 at 8:12 PM
    #3
    chris4x4

    chris4x4 With sufficient thrust, pigs fly just fine Moderator

    Joined:
    Jul 19, 2016
    Member:
    #2
    Messages:
    3,177
    Gender:
    Male
    Welcome!
     
To Top