1. Welcome to Jeeps.net!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Jeep discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Jeep owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Shock Pressure

Discussion in 'Wrangler YJ (1986-1995)' started by Jeeperskreepers, Mar 15, 2017.

  1. Mar 15, 2017 at 6:31 PM
    #1
    Jeeperskreepers

    Jeeperskreepers [OP] New Member

    Joined:
    Mar 15, 2017
    Member:
    #1155
    Messages:
    1
    Gender:
    Male
    First Name:
    Jeremy
    Vehicle:
    93 YJ
    Custom Stroker 6, Currie 9inch front and rear 35 spline inner Detroit Lockers, Atlas Tranfer Case, Rockkrawler Long travel Suspension, 37.5x14.5x15 Toyo MTR Tires.
    Does anyone in here know what a Monotube coil over pressure should be set at? My RRD Shock were shipped with no Pressure in them and I would like to know what to set them at. I have a Rockkrawler Suspension I just put on it and it rolls a lot from the Torque of the Drive Train. Hate it.
     
  2. Mar 15, 2017 at 8:21 PM
    #2
    chris4x4

    chris4x4 With sufficient thrust, pigs fly just fine Moderator

    Joined:
    Jul 19, 2016
    Member:
    #2
    Messages:
    4,068
    Gender:
    Male
    Welcome! Depending on valving, Ive run 100 to 180 psi in shocks. The pressure doesn't have as much of an effect on the shock actuation as one might think, but you can use it to "fine tune" the behavior. Nitrogen and high pressure is used to reduce cavitation of the oil inside the shock.
     
To Top